As Featured in
Small Arms Review
 
"New Review"
New Products by Chris Choat
Vol. 2 No. 5, February, 1999

JB Manufacturing is now manufacturing and marketing the Tac-Latch II, a "Do-it-yourself", easily installable magazine release mechanism for the H&K "Black Rifles". The Tac-Latch II is an improved version of the original Tac-Latch introduced in the early 1980's. The Tac-Latch II provides the H&K shooter with a magazine release that can be used with the left hand much like the "flapper" mag release on the full-auto H&K's. The Tac-Latch II is easily installed with only a roll pin punch and a hammer. The installation takes only a few minutes and best of all, the Tac-Latch II is priced at a fraction of the cost of an original H&K mag release plus installation. The only difference in the Tac-Latch II and the original H&K mag release is that the flapper on the Tac-Latch II is pushed to the side instead of forward to release the magazine. The new release is made of solid 1018 steel for years of use and is black oxide coated to match the weapons finish. There is also an anti-rattle spring incorporated into the Tac-Latch II for quiet operation. It comes in two models, one for the 308/223 (G-3, 91, 53, 93) series of guns and one for the 9mm (MP-5, 94, SP-89). This new release is made right here in the good ole' USA and carries a life-time warranty. For more information or to place an order contact: JB Manufacturing, Dept. SAR, 3680 W 4975 S, Roy, Utah 84067. Phone: 1-801-985-3990. Web Site: www.taclatch.com.

 ·  H o m e  ·  H i s t o r y  ·  I n s t a l l a t i o n  · 

 ·  P h o t o s  ·  O r d e r  ·  C o n t a c t   U s  ·